Can I Cook A Jack O Lantern Pumpkin



For fancier designs and easy pumpkin carving, you may want to invest in a few safer and more exact implements, such as tiny saws and an awl . Scoop the seeds and pulp out of the pumpkin with a spoon. Start by pulling out as much of the pulp and seeds as you can by hand and put them in a large bowl. Then, scrape the inside walls of the pumpkin with any large stiff spoon, ice cream scoop, or scraper from a carving kit. Keep scooping out the pulp until the pumpkin is about 1–2 inches (2.5–5.1 cm) thick.

And we like the Homemory Flameless LED Tea Light Candles to light it up. Light one or two small tea lights and set them on the bottom of your pumpkin. Put the lid back on your pumpkin to light up your design so it’s visible. Just make sure to blow the tea lights out at the end of the night so they don’t stay lit or cause a fire. A pumpkin carving kit usually comes with a sharp tool you can use to poke holes. Once you're done carving your design, you'll want to see how it shines by lighting the pumpkin up!

Use an up-and-down sawing or rocking motion to cut through the skin. Start by making rough cuts to remove large sections and go back to clean up the edges. Follow our pumpkin carving tips to look like a pro when carving your next Jack-o’-Lantern.

Evan and Soria have found that putting jack-o’-lanterns right outside your door can dissuade larger animals from stopping by for a bite. We do not recommend brining pumpkins, spraying them with bleach or, um, coating them in WD-40, as some questionable advisors on the internet might suggest. Any of these options can be harmful to wildlife—not to mention that they are a lot of work for what might still be little or no payoff.

Once you have finished carving, spray or wipe the inside of the cavity, and all the cut surfaces, with an essential-oil-based cleaning spray. Or soak the finished pumpkin overnight in a tub of borax water. Use long fireplace matches or a lighter with a long neck to help protect your fingers and hands while lighting a candle inside a jack-o’-lantern. If you cut your initial opening in the bottom, this isn’t an issue as you just light the candle out in the open and then lower the jack-o’-lantern over it. Once you’ve made a cut you can’t erase it, so it’s a good idea to sketch your design onto the surface Krazy of the pumpkin before picking up a cutting tool. A felt tip marker works well for sketching and drawing.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15